Alphacom 32 Podręcznik użytkownika - Strona 2
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Drukarka Alphacom 32. Alphacom 32 4 stron.
Również dla Alphacom 32: Podręcznik użytkownika (4 strony)
Drukuj stronęCONNECTING POWER TO YOUR PRINTER The printer receives its power from a
separate power adaptor which can be plugged into any proper source of power. See label on
Power Adaptor. Since power is applied to the internal circuitry whenever the adaptor is
connected, it is necessary yo unplug the power adaptor to completely turn off the printer. Do
not place anything on top of the printer when it is plugged in as that will interfere with the air-
cooling process.
CONNECTING TO YOUR COMPUTER Before connecting anything to your computer,
REMOVE POWER PLUGS from the computer and the printer. If you are using a RAM
pack, disconnect it from the computer. The edge socket on the end of the printer's cable snaps
into the rectangular slot in the back of the computer. If you are using a RAM pack, snap it into
the rectangular slot in the back of the printer connector. Now plug the power connector into
the back of your printer and press the On/ADVANCE button once. You are now ready to load
the paper.
THE PRINTER PAPER The printer is designed to use standard thermographic printing
paper in roll form. Included with your printer is a roll of Alphacom recommended paper
which has a 1.9" diameter. Replacement rolls of this paper are available at outlets carrying the
Alphacom printer.
Make sure that the correct paper is always used, for sensitivity and smoothness of the paper is
important for correct operation of the printer. Incorrect, or low-quality paper may result in
poor heat transfer, smearing, and poor print contrast. IMPORTANT: Avoid use of abrasive
papers, which can cause severe head damage in less than two hours of printing. For quality
printing and longer head life use only Alphacom recommended paper.
WARNING This product contains no user serviceable parts inside, and the user should not
open the protective plastic case. All normal operations can be conducted without opening the
case. If the plastic cover is damaged through breakage, discontinue use of the appliance until
the unit can be examined and repaired by an authorized Service Center.
LOADING ROLL PAPER INTO THE PRINTER Paper loading may be easily
accomplished by following the steps shown in Figures 2, 3 and 4.
STEP 1: Open the paper receptacle cover.
STEP 2: Place the paper roll in the printer paper tray with about 6" of the paper coming
from underneath the roll. Insert the leading edge of the paper below the rubber platen, and
press the ON/ADVANCE button. The paper will feed automatically. See Figure 2.