Axminster AW12BM Podręcznik użytkownika - Strona 17

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Wiertarka Axminster AW12BM. Axminster AW12BM 20 stron. 12mm bench morticer

General Precautions Whilst Using a Drilling Machine (Continued)

9. It is a good precaution to wear eye protection when drilling, especially using small drills, or

very hard material that produces small chips.

10. It is not a good idea to wear gloves when operating a drill press.

11. After the job is completed, remove all tools and accessories from the machine, check that

drill bits are still sharp and re-useable. Clean the machine down thoroughly, including removing

coolant or cutting compounds from the drill table. Lightly coat all metal surfaces with a light oil

coating. Disconnect the machine from the supply. Secure the cable/plug clear of the floor.

There is very little maintenance required on your morticer.

Keep it clean

Make sure the rack and pinion gears do not become clogged with chips/sawdust.

Lightly spray oil on all exposed metal surfaces if the machine is going to stand idle for

any length of time. Keep the chisels and augers sharp.

Once a month

Blow/suck the motor to remove any debris that might have lodged in the fan cover. Oil

the chuck and exercise it over its full range to ensure the oil coats all moving parts.

There are full ranges of mortice chisels and a useful sharpening set listed in Section 1 of

the Axminster catalogue.

Maintenance

Oil

OIL