Axminster Craft AC150WSG Oryginalna instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Oryginalna instrukcja obsługi dla Szlifierka Axminster Craft AC150WSG. Axminster Craft AC150WSG 13 stron. Wide stone grinder
Drukuj stronę
1. Do not operate your machine until it is completely
assembled and installed according to the instructions.
2. If you are not familiar with the operation of grinding
machines obtain advice from your supervisor or
instructor or another qualified person.
3. Only use grinding wheels or attachments rated higher
than 3600 rpm with a 5/8"(16mm) arbor on this
machine.
4. Never use a chipped or cracked wheel. Always inspect
each wheel before mounting it on the grinder. If during
inspection you discover a damaged grinding wheel;
replace it immediately.
5. Do not over tighten wheel nuts.
6. Always maintain a distance of 2mm or less between
the wheel and the tool rest. Adjust the tool rests as the
wheels decrease in size.
7. Ensure the tool rests are tightened so they cannot move
while in use.
8. Never grind on a cold wheel. The grinder should always
be run for at least one minute before applying work to it.
9. Never grind on the side of the wheel. Always grind on
the face of the wheel only.
10. Never apply coolant directly to a grinding wheel,
it may cause the bonding to fail. If the work piece
becomes hot, dip it into a water pot to cool it down.
Specific Safety Precautions for Grinding Machines
11. Hot sparks are a hazard! Never carry out grinding
12. Always make sure the spark guards and eye shields are
13. Keep the sparks guards close to the wheels and
14. Ensure the soft washer and the flanges furnished
15. Always stand to one side of the grinder when starting
16. Avoid awkward hand positions where a sudden slip
17. If the wheel requires dressing, dress only the front of
18. Do not use any attachments that causes the machine
19. Grinding creates heat. Do not touch the work face of
7
operations near flammable gas or liquid.
in place, that they are properly adjusted and secured.
re-adjust them as the wheels wear.
with the grinder, are used to mount any attachments
(grinding wheels, wire brushes, buffing wheels, etc)
onto the shaft.
the machine.
could cause the hands to come into contact with a
grinding wheel, wire brush etc.
the wheel, do not dress the sides.
to vibrate. If after changing grinding wheels or adding
attachments, the machine does vibrate; remove the
recently replaced item and change again.
the work piece until you are sure it has cooled down
sufficiently.