Axminster Trade 501210 Skrócona instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Sander Axminster Trade 501210. Axminster Trade 501210 17 stron. 300mm disc sanders

Setup/Adjustments

Setting the table clearance

The gap between the table and the disc should be set to

a maximum of 1.6mm to clear the debris and to ensure

sufficient support for the timber.

The table should be positioned so that sanding only occurs

from downward movement of the disc face. Small pieces of

timber should not be disc sanded. A responsible person

should check the setting of the machine before use.

Step 1 To set the table clearance, first remove the guard by

undoing the two Phillips screw (a), place screws and guard

safely aside (see fig 01).

Fig 01

Fig 02

Step 2 Locate the supplied spanner (C) loosen the six nuts

beneath the table brackets, (see fig 02) place a rule up

against the sanding disc and adjust the table until there is a

1.6mm clearance between the table and the disc, (see fig 03).

Step 3 Replace the disc guard as described above.

Step 4 Place the 90˚ square against the disc and mitre fence,

(see fig 04) to check the table is square then tighten the six

nuts beneath the table.

Place a rule up against the sanding disc and adjust the table

until there is a clearance of 1.6mm.

Step 5 Place the square upright against the sanding disc,

loosen the two clamping handles (b) on either side of the

table and adjust the tables angle, until it's perpendicular to

the sanding disc (see fig 05). Tighten the clamping handles.

90˚Square

NOTE: MAKE SURE THE MITRE

FENCE IS SET TO ZERO ON THE

SCALE!

90˚Square

Fig 03

Fig 04

Fig 05