AccuPower APLC4S2A Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Ładowarka AccuPower APLC4S2A. AccuPower APLC4S2A 2 stron. Li-ion charger, rapid charger unit for lithium-ion and lithium-polymer rechaargeable battery packs with 4 cells 14.4v or 14.8v

Drukuj stronę
This charger is designed for use with Lithium-ion and Lithium-polymer batteries. For safety
reasons, this charger must be used only for Lithium-ion and Lithium-polymer batteries which
have 4 cells in series: Output voltage 14.4 V or 14.8 V.
Do not attempt to charge batteries that are not expressly stated by the manufacturer to be
suitable for the currents the charger delivers during the charge process.
Do not attempt to charge faulty or damaged batteries.
The mains socket should be easily accessible. In the event of operational error, the plug should
be immediately removed from the socket.
The product contains dangerous voltages and the cover should not be removed. All service or
maintenance work should be carried out by authorised personnel or through a representative of
the manufacturer.
The charger has internal fuse which blows if a fault occurs in the charger. Such faults must be
repaired by qualified service personnel.
The charger is double-insulated (in insulation class II).
Products with plastic casing should not coming into contact with oils, grease etc., as most types
of plastic can be broken down by chemicals and solvents.
The manufacturer accepts no liability or responsibility for damages caused by incorrect
operation, failure to follow the Instructions for Use, failure to comply with the maintenance
instructions, incorrect maintenance or any other form of incorrect handling or misuse of the
device, whether by the buyer or by third parties (e.g. incorrect operation, wrong connection,
wilful damage, etc.).

CHARGING INSTRUCTIONS

ATTENTION: The charging instructions of the battery manufacturer must be observed!
1. Do not connect the charger to the mains before it is connected to the battery.
2. Observe correct polarity when connecting to the battery terminals.
3. Connect the charger to the mains.
4. When charging is complete, disconnect from the mains before removing battery connections.
LED indicator:
Red:
Green: Standby / charge completed
Instruction Manual: Li-Ion C
Battery is charging
2/2
harger
Web: www.accupower.at
APLC4S2A