ACCUR8 YD8230A-4UK Podręcznik użytkownika - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Stacja pogodowa ACCUR8 YD8230A-4UK. ACCUR8 YD8230A-4UK 7 stron. Weather forecast station

Radio-controlled Time Setting

Important notes:

•

It can help to place the display console near an open window when carrying out the above.

•

When searching for the radio-controlled time signal, the display screen will be dimmed.

In Normal mode, press MODE button to start or stop receiving the radio-controlled time signal.

When successfully receiving the DCF RCC signal, set the time zone for the UK:

1. Press and hold the MODE button for approximately three seconds to enter the Time Setting mode. Digits to

be set will flash.

2. Press the DOWN button once to set the time zone to "-1".

3. Exit the setting mode and the correct UK time will be shown.

Manual Time Setting

1. Press and hold the MODE button for approximately three seconds to enter time setting mode.

2. Digits to be set are flashing.

3. Press UP or DOWN button to change the value.

4. Press the MODE button to confirm and continue to the next setting.

5. Finally press the MODE button to save the settings and exit the setting mode.

Settings order: Time zone > 24hr/12hr > Hours > Minutes > Year > Month > Day > °C/°F > Barometric unit >

Language for week display > Country > City.

Alarm Time Setting

1. In Normal mode, press the ALARM button once to enter the Alarm mode.

2. In Alarm mode, press ALARM button again to turn on or turn off the Alarm.

3. In Alarm mode, press and hold the ALARM button for approximately three seconds to enter the Alarm time

setting mode. Digits to be set are flashing. Press UP or DOWN button to change the value. Press MODE

button to confirm and continue to the next setting. Settings order: Hour > Minute.

In Alarm mode, Press the MODE button to return to Normal mode.

MAX/MIN Temperature and Humidity

1. In normal mode, Press the UP button to check the Max and Min temperature and humidity records.

2. In Max/Min temperature and humidity mode, press and hold the UP button for approximately three seconds

to clear the record.

Replacing Transmitter Batteries / Receive New Readings

If you have replaced the batteries on a remote transmitter, or would like to receive updated readings, press

and hold the DOWN button for approximately three seconds. After three seconds, you will see "---". Regaining

new readings can take up to three minutes.

SNZ/LIGHT

1. Press the SNZ/LIGHT button once to turn on the backlight for 10 seconds.

2. When the alarm rings, press the SNZ/LIGHT button to enter the snooze function.