Cintroclear UF 400 Instrukcja instalacji - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Systemy filtracji wody Cintroclear UF 400. Cintroclear UF 400 9 stron.

Follow the pressurisation procedure described below carefully, this will ensure that the purifier is

completely purged and all trapped air is removed. During this purge operation, the unit may briefly produce

some slightly coloured water, this is perfectly normal.

1) Open the pure water tap to the permanent flow position (lever locked in the raised position).

2) Slowly open the purifier inlet valve until it is fully open.

3) Let the tap with purified water run for 6 minutes (this period of time is essential for proper

functioning).

4) Leave the pure water tap open and close the inlet valve for approximately 1 minute.

5) Open the tap at the entrance to the purification device again and let the water run from the tap

with purified water for at least 2 minutes.

6) Close the pure water tap.

7) Open the pure water tap to the permanent flow position and allow it to run for 1 minute.

8) Purging and commissioning of your Cintroclear purifier is now completed.

The card that hangs on your purifier reminds you that its maintenance is essential to keep a good water quality

with the passing years. The maintenance of your CINTROCLEAR UF 400 must be done once a year. On this

card bellow with pre-printed calender you can put a cross to mark the next maintenance.

Your Cintroclear UF400 is meant for domestic use. The period of time between 2 maintenances is based

thereon.

Commissioning the purifier UF 400

Pressurisation of the purifier :

Maintenance