AXTON AC25ES Podręcznik - Strona 11

Przeglądaj online lub pobierz pdf Podręcznik dla System głośników AXTON AC25ES. AXTON AC25ES 16 stron. Ac 2-way component system

TWEETER INSTALLATION

There are two ways to install the AT25 tweeters: Angled surface or fully recessed moun-

ting.

Flat Surface Mounting

The tweeter system consists of three parts: The main tweeter unit, the backside of the

housing adapter and the front ring.

Mark the location where you are going to mount the tweeters. Drill three holes on each

side, one main hole with a bigger diameter for the wire and two small pilot holes for the

two screws fixing the tweeter housing to the mounting surface.

Mount the adapter cup with two flathead screws.

Feed the wire through the hole and connect it to the wire extension that goes to the

crossover. Align the front ring over the the tweeter main housing, push it down

and turn the ring clockwise to fix it in place (bayonet design).

Flush Mounting

After choosing the best mounting location, make sure there is at least 25 mm of clearance

behind the mounting surface (for the tweeter cross-spring!), before you start to mark or cut

anything!

Cut a hole with exactly 52 mm diameter into the mounting surface using a power drill and

a circle cutter tool.

Secure the flush mount tweeter adapter in the cutout with the metal cross blade and

the two machine screws provided in the mounting accessory kit. Push the main tweeter

down into the rear cup with the frontring on top, turn clockwise to lock it. Feed the wire

through the center hole of the cup and attach the wire to the extension cable that goes to

the crossover.

CROSSOVER WIRING & MOUNTING

The crossover can be mounted in almost any location inside the vehicle. Recommended

places are: Inside the door, under the carpet in front of the door angles, under the dash-

board a.s.o. Just make sure not to install the crossover units, where they may be exposed

to dirt or excessive moisture / water.

Connect the tweeter wires, the wires from the mid/woofers and the main wires coming

from the amplifier to the crossover. Maintain polarities all the way – double check for cor-

rect connection. It is very important to make sure that all the connections are electrically in

phase, which means positive wire (+ or red) is connected to positive terminal, and negative

wire (- or black) is connected to the negative terminal.

Reverse polarity connections, i.e. when a mid/woofer is concerned, will cause a very low

bass output and a messed up front staging.

If longer distances from the amplifier to the crossovers have to be overcome, use good

quality speaker cables with a minimum cross section of 2.5mm². Failure to do so will affect

sound quality in a negative way.

AC25 AC26_ES Manual.indd 11

– 11 –

16.03.2007 19:04:11 Uhr