Axxera AX450DM Instrukcja instalacji i obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Wzmacniacz Axxera AX450DM. Axxera AX450DM 13 stron. Mobile power amplifiers

Speaker Connections

Connect speaker wires

observing polarity. The

minimum impedance load

for the AX4150D is 2 ohms

stereo and 2 ohms bridged.

Use of loads lower than these

is not recommended and may

cause amplifier damage. The

AX4150D can be wired for

stereo, bridged or stereo/

bridged simultaneous operation.

Input Signal Connections

Low Level Input (RCA)

Low level (RCA) input signal is preferred for best performance. Typical trunk-mount

amplifier installations require a 17-20 foot RCA cable. Most trucks and under-seat

applications require a 6-9 foot RCA cable. Using twisted pair construction RCA

cables will minimize noise.

Low-Level Input

(RCA)

Note: Do not use both low and high level inputs

at the same time - connect only one or the other.

INSTALLATION

Amplifier Connections

High-Level Input

(speaker cables)

2 Speakers (stereo)

Typical Stereo Wiring

(2 ohms minimum)

Typical speaker connections shown

High Level Input

(Speaker Wire)

High level inputs should only be

used when RCA outputs are not

available from the head unit.

Connect the head unit speaker

outputs to the high level input

connector as shown below. The

black wire (signal reference

ground) may or may not require a

connection to chassis ground

- depending on your particular

installation.

Subwoofer (mono)

Typical Bridged Wiring

(2 ohms minimum)