Axxess GMOS-LAN-01 Instrukcja instalacji - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt nagrywający Axxess GMOS-LAN-01. Axxess GMOS-LAN-01 8 stron. Gm onstar lan data bus interface
INSTALLING THE GMOS-LAN-01
1. With all connections completed, plug the 14 and 12 pin harnesses into the GMOS-LAN-01.
2. Reconnect the negative battery terminal.
3. Plug the 30 pin GM harness into the vehicle side harness, and plug the aftermarket radio harness into the
aftermarket radio.
4. Cycle the key by turning the ignition on then back off, then back on again to test the radio.
TESTING THE GMOS-LAN-01
1 Turn the ignition on, and then turn the aftermarket radio on.
2 Push the Onstar button, the radio should turn off and you should hear Onstar. Push the Onstar cancel button
and the radio should come back on.
CHIME VOLUME ADJUSTMENT
To adjust the chime volume, use a small screwdriver to rotate the potentiometer, located on the 14 pin harness side
of the interface, clockwise to make the chime louder and counterclockwise to make the chime softer.
ONSTAR LEVEL ADJUSTMENT
To adjust the Onstar volume level find the Black/Yellow wire on the 12 pin harness. Push the blue Onstar button,
while the voice is speaking tap the Black/Yellow wire to ground. There are 4 volume settings for Onstar; once the
4th setting is reached and the Black/Yellow wire is tapped to ground it will automatically go back to the first vol-
ume setting. Once the volume is set it will stay at that volume until the Black/Yellow wire is tapped to ground
again. This can be set during installation and then left alone. If user adjustment is desired, a momentary contact
switch (sold separately) can be added. Connect one terminal from the switch to ground and the other terminal to the
Black/Yellow wire. The volume will change one level every time the switch is pressed.
AUDIBLE TURN SIGNAL
When the factory radio is removed the audible turn signal indicator is lost.
If that turn signal "clicking" is desired follow these steps:
1. Using a SPDT relay (Metra part # E-123), connect pin #85 to the Black/White wire in the 12 pin harness.
2. . Connect pin #86 to the 12 volt constant wire on the 12 pin harness.
3 . Be sure to cover the other leads of the relay by either using female spade connectors or using tape to cover
the leads.
Now when the turn signal is on, the relay will make the audible "clicking" noise.
877.312.4547
REV. 12/1/10 © COPYRIGHT 2004-2009 METRA ELECTRONICS CORPORATION INSTGMOS-LAN-01
GMOS-LAN-01
www.solidsignal.com
7