Axxess OESWC-CLASS2H Instrukcja instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Części samochodowe Axxess OESWC-CLASS2H. Axxess OESWC-CLASS2H 8 stron. 03-up class2 harness for oe rf/stk

Drukuj stronę

5. This is the end of the auto detection stage. If the OESWC TRANSMITTER

detected the vehicles radio successfully the led will light up solid red.

6. Make sure the steering wheel control buttons function correctly in the vehicle

and enjoy your radio.

So what if the led does not light up solid red?

Check out troubleshooting section below.

Troubleshooting the Auto Detect Mode

So you tried the auto detect feature and at the end the led did not stay on solid

red, it started flashing. That means the OESWC TRANSMITTER did not detect

the vehicles radio. Follow these couple steps to determine what happened:

First some basic steps:

1. Verify that you have 12 volt accessory and a good ground to the OESWC

interface.

2. Verify that the battery is good on the OESWC transmitter.

3. Refer to the "Setting up the OESWC transmitter" section of this manual and

repeat those steps.