Axxess AX-ADGM04 Instrukcja instalacji - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Kable i złącza Axxess AX-ADGM04. Axxess AX-ADGM04 12 stron. Gm data interface 2012-2016

CONNECTIONS TO BE MADE

12-pin pre-wired ASWC-1 harness:

This harness is to be used along with the optional ASWC-1 (sold separately) to retain steering

wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If the ASWC-1

will be used, please refer to the ASWC-1 instructions for radio connections and programming.

Disregard the harness that comes with the ASWC-1.

The DIN jack is to be used with the optional AX-LCD (sold separately) to retain satellite

radio information for models that do not retain this information in the driver's information

center. The AX-LCD can also be used to view which factory sources are active; rear seat

entertainment, satellite radio, AUX-IN.

(CONT.)

Attention! The AX-ADGM04 will work with both the AX-ADBOX1 and AX-ADBOX2 interfaces,

but programming will be different. Refer to the proper page for whichever interface is being

used. Also note, the programming instructions for the AX-ADBOX2 reflect gen. 2. If installing a

gen. 1 AX-ADBOX2, refer to the AX-ADBOX1 programming instructions. Gen. 2 interfaces can be

distinguished by a blue reset button between the (2) connectors.

Installing the AX-ADGM04

With the key in the off position:

• Connect the 16-pin harness with stripped leads, and the AX-ADGM04 harness, into the interface .

• Connect the AX-ADGM04 harness to the wiring harness in the vehicle.

• If an ASWC-1 (sold separately) will be used, do not connect it until the AX-ADGM04 is

programmed and fully functional.

Programming the AX-ADGM04

Attention! If the interface ever loses power, the following steps will need to be performed

again. Please ensure that the owner of the vehicle knows this.

• Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.

Note: If the radio doesn't not come on within 60 seconds, turn the key to the off position,

disconnect the interface, check all connections, reconnect the interface, and then try again.

• Turn the key (or push-to-start button) to the off position, then to the accessory position.

Test all functions of the installation for proper operation, before reassembling the dash.

Note: To use fade in digital amplified models, ensure the radio is turned up 3/4 of the way.

Continue to Adjusting the AX-ADGM04

INSTALLING & PROGRAMMING

THE AX-ADGM04