Epson ActionLaser 1400 Podręcznik użytkownika - Strona 5
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Drukarka Epson ActionLaser 1400. Epson ActionLaser 1400 30 stron. Flatbed inkjet printer
Również dla Epson ActionLaser 1400: Podręcznik użytkownika (8 strony), Przeczytaj tę pierwszą instrukcję (27 strony)
Drukuj stronę
Flatbed Inkjet Printer
3．Keep enough space up & down for the movement of the flatbed。
4．When the power of printer in status of OFF, please be
careful to insert power cord to the jack.
5．Then please switch on the power in the rear of the printer,
press the "down" key to move the flatbed to an apropos position, take away the protect materials
for the flatbed.
6．The power pin, power cord, data cable must connect fine,
fastness with computer, avoiding wrecked the printer due to suddenness shed.
7．When exit factory, any parts of the printer should be fixed by adhesive tape, please take them
away before use the printer.
8．The print-head is fixed by special steel piece for protection before exiting factory, before using
this printer, please draw out the steel piece from print-head.
D：Inkjet Ink to the printer
1, when you going to inkjet ink to the printer, please Screw off the cap of the ink tank, draw off the ink
House, take off the packet of the ink pipe, and use The 50ml injector which with soft pipe to suck
& inkjet ink to the printer, but please take attention to the according ink volume in the bottle.
2. Pump ink
When you are going to pump ink, after injecting ink to the printer, please take the ink bursa away
from ink cartridge orderly from 1 to 6, (as picture below)。Use injector to draw ink（As picture right） ，
and draw ink to the ink burs, perform it by order from 1 to 6, when the ink reach to volume 2/3 of the
bottle would be fine, after injection, please recover the bursa to the cartridge of the print head。
５
５