arcelik OCD 608 YI Podręcznik użytkownika - Strona 13
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Hob arcelik OCD 608 YI. arcelik OCD 608 YI 16 stron.
Drukuj stronęDANGER:
The product must be connected to the
mains supply only by an authorised and
qualified person. The product's
warranty period starts only after correct
installation.
Manufacturer shall not be held responsible
for damages arising from procedures
carried out by unauthorised persons.
DANGER:
The power cable must not be clamped,
bent or trapped or come into contact
with hot parts of the product.
A damaged power cable must be replaced
by an Authorised Service Agent. Otherwise,
there is risk of electric shock, short circuit
or fire!
•
Connection must comply with national
regulations.
•
The mains supply data must correspond to
the data specified on the type label of the
product. Type label is at the rear housing of
the product.
•
Power cable of your product must comply
with the values in "Technical specifications"
table.
DANGER:
Before starting any work on the
electrical installation, disconnect the
product from the mains supply.
There is the risk of electric shock!
Power cable plug must be within easy reach
after installation (do not route it above the
hob).
Plug the power cable into the socket.
Gas connection
DANGER:
Product can be connected to gas
supply system only by an authorised
and qualified person.
Risk of explosion or toxication due to
unprofessional repairs!
Manufacturer shall not be held responsible
for damages arising from procedures
carried out by unauthorised persons.
DANGER:
Before starting any work on the gas
installation, disconnect the gas supply.
There is the risk of explosion!
•
Gas adjustment conditions and values are
stated on labels (or ion type label).
Your product is equipped for natural gas
(NG).
•
Natural gas installation must be prepared
before installing the product.
•
There must be a flex pipe at the outlet of
the installation for the natural gas
connection of your product and the tip of
this pipe must be closed with a blind plug.
Service Representative will remove the blind
plug during connection and connect your
product by means of a straight connection
device (coupling).
•
Make sure that the natural gas valve is
readily accessible.
•
If you need to use your product later with a
different type of gas, you must consult the
Authorised Service Agent for the related
conversion procedure.
If there is a built- - - - in oven installed under the
If there is a built
If there is a built
If there is a built
in oven installed under the
in oven installed under the
in oven installed under the
hob;
hob;
hob;
hob;
•
Gas hose must be routed in a way not to
touch the sharp edges and corners beneath
the hob and not to be kinked or twisted.
If you will make the gas connection from left
hand side when viewed from your position,
fix the hose with clamps.
13/EN