Epson DFX-9000 Podręcznik użytkownika - Strona 20
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Drukarka Epson DFX-9000. Epson DFX-9000 28 stron. 9-pin dot matrix printer
Również dla Epson DFX-9000: Podręcznik użytkownika (28 strony), Specyfikacje (2 strony), Aktualizacja oprogramowania sprzętowego (1 strony), Skrócona instrukcja obsługi (12 strony), Specyfikacje (2 strony), Zacznij tutaj (2 strony)
Drukuj stronę
http://www.ochimp.com
9.
If you want to save the settings, select
button. If you don't want to save the settings, select
D (
) button. The printer exits SelecType mode.
Set
Top of Form
Note:
If you turn off the printer prior to exiting the SelecType mode, any changes you have
made are canceled and not saved.
Default-setting Mode
Use the Default-setting mode if you need to adjust the print head position for
printing on uneven forms or to choose which control panel buttons to lock
when Lock-out mode is turned on. (See page 21 for more information about
Lock-out mode.)
Continuous forms with labels
If you are printing on forms of varying thicknesses—for example, a form that
includes a label in addition to standard printing—you may need to adjust the
setting. By defining the position of the label, you tell the printer
Forms w/labels
where it needs to raise the print head to accommodate the greater thickness as it
prints over the label.
Before you can change the settings for continuous forms with labels, use
SelecType as described on page 19 to make sure the
to
.
On
For More Info
Click Here ===>
20 Default-setting Mode
http://www.ochimp.com
by pressing the
U (
)
Yes
Set
Tear Off
by pressing the
No
setting is set
Forms w/labels
Note:
You do not need to change these settings for printing label sheets of uniform thickness.
Setting
Options (default in bold)
Label base position
Paper left edge, First dot
Label top position
0 to 4752/216 (0 to 22" in 1/216-inch increments)
Label length
0 to 4752/216 (0 to 22" in 1/216-inch increments)
Label left position
0 to 1440/120 (0 to 12" in 1/120-inch increments)
Label width
0 to 1440/120 (0 to 12" in 1/120-inch increments)
Base sheet PG (platen gap)
0 to 14*
position number
Label paper PG (platen gap) position
0 to 14**
number
*
Adjusts the platen gap for printing on label carrier (base sheet).
** Adjusts the platen gap for printing on labels affixed to label carrier.
Lock-out mode settings
Button function
Settings (default in bold)
Pause
Unlock, Lock
Micro Feed
Unlock, Lock
Load
Unlock, Lock
LF
Unlock, Lock
FF
Unlock, Lock
Top of Form
Unlock, Lock
Tear Off
Unlock, Lock
Font
Unlock, Lock
Pitch
Unlock, Lock
Front/Rear
Unlock, Lock
Menu
Unlock, Lock
Reset
Unlock, Lock