ARCHIPELAGO LIGHTING LEMX Instrukcja instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt oświetleniowy ARCHIPELAGO LIGHTING LEMX. ARCHIPELAGO LIGHTING LEMX 5 stron.

LEMX - Installation Guide

LED Lamp Heads: LEMX-L2Sx

1. Remove the face cover by gently prying it open with a

flat screwdriver.

2. Pass the wires through the mounting holes on the

housing. Insert lamp heads into housing and twist them to

lock firmly.

3. Connect the wires of lamps into the PCB terminal as

shown (Fig. C).

4. If luminaire is to be wall mounted or ceiling mounted,

move onto the next page for reference. Otherwise, install

the back of the face cover to complete the assembly

Wall Mount: LEMX-L2Sx

1. Knock out the proper hole pattern in the back plate

to mount to a standard junction box. Place a support on

either side of the knockouts to be removed and then

knock out with a screwdriver (Fig. A).

2. Using a flat screwdriver, remove the front cover, remove

and discard the canopy kit.

3. Feed excess wires into the junction box.

4. The system can accept input voltages of 120 VAC or

277 VAC. Connect the black/red wire (line voltage) and the

white wire (neutral) leads to the building utility. Connect

the green ground.

5. Using the junction box screws to mount spider plate

onto junction box (Fig. C).

6. Mount the unit securely to the junction box using the

junction box screws.

7. Snap the EXIT plate to the unit (Fig. D).

8. If the EXIT needs to point to certain direction,

arrow can be removed.

Headquarters: 4615 State Street, Montclair, CA 91763

Production Center: 7345 Syncamore Canyon Blvd, Riverside, CA 92508

1. Fig. A

3. Fig. C

1. Fig. A

6, 7. Fig. D

2. Fig. B

4. Fig. D

2, 3, 4. Fig. B

5. Fig. C

8. Fig. E

archipelagolighting.com

+1(866) 912-3220