CREE LIGHTING ZR22MT-SC1 Instrukcje instalacji - Strona 3
Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Oprawa oświetleniowa CREE LIGHTING ZR22MT-SC1. CREE LIGHTING ZR22MT-SC1 5 stron. Commercial specification troffers with emergency driver & smartcast technology
Drukuj stronę4
5
Large Trim Ring
Test Switch
Small Trim Ring
6
Loose End Cap
7
3 of 5
Reset Button
Motion Sensor
Ambient Light Sensor /
Blue LED indicator
Ceiling
Fixed End Cap
Lens
Fixed End Cap
RESET
STEP 1:
Actuate RESET button through the access hole. Press
and hold Test/Reset button until the LED flashes fast
(approximately 5 seconds). See Figure 4.
STEP 2:
Release the Test/Reset button for 1 second (Fast flashing
continues). Press and hold Test/Reset for 1 second until fast
flashing stops. If the blue LED does not respond with the
two-blink sequence, please repeat the RESET procedure..
INSTALLING TEST SWITCH
STEP 1:
Install test switch assembly into ceiling by drilling a 1" hole
into the ceiling.
STEP 2:
Unscrew the small trim ring and place test switch assembly
through the ceiling. See Figure 5.
STEP 3:
Secure the test switch assembly by screwing the small trim
ring removed in Step 5 back onto the test switch assembly.
Tighten the larger trim ring above the ceiling until it is
snugged tight against the ceiling. See
Figure 5.
CLEANING LENS
STEP 1:
Remove lens and endcap by pulling down gently on one end
near endcap. See Figure 6.
STEP 2:
Before installing lens, ensure that one endcap is already
installed.
STEP 3:
After cleaning is complete, place loose endcap back onto
lens and angle lens into fixed endcap. After getting lens
seated into fixed endcap, rotate upwards to engage loose
endcap into position. See Figure 6. Lens may need to be
squeezed together to help guide into pan.
STEP 4:
Confirm there are no visible gaps along entire length of lens
and around endcaps. If necessary, push endcaps against
end panel or lens against luminaire to eliminate gaps
NOTE: If fixed endcap comes loose during removal, push
upwards while using end panel as a stop to engage clips
See Figure 7.
LPN00696X0001A0_A