Creek Company VOYAGER FRAMELESS PONTOON Instrukcja montażu - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Łódź Creek Company VOYAGER FRAMELESS PONTOON. Creek Company VOYAGER FRAMELESS PONTOON 4 stron.
Drukuj stronę
Your ODC Outdoor Discovery Craft™ is designed to give you many years of service.
Please follow inflation instructions and warnings carefully.
If you ever have any questions or problems with your VOYAGER™ please do not return it to the
dealer you bought it from. Please contact the Creek Company directly toll free at 1-800-843-8454.
We are open M-F 9am-5pm mountain time. Or contact us via e-mail at [email protected].
1. Always wear a US Coast Guard approved personal flotation device when in your VOYAGER™
2. Never float alone.
3. Always check your VOYAGER™ Air Bladders, outer skin and stitching for possible damage before you
use your craft.
4. Never use your craft if you suspect the Air Bladders, outer skin or stitching has been damaged.
5. Never overinflate your VOYAGER™
6. Never use your VOYAGER™ without the Pontoons fully inflated.
1. If your Pontoon Bladder is losing air, please check that Valve Assembly and Top Valve Cap are fully seated. Reseat
valve assembly and repeat pontoon inflation instructions.
2. Do not store your VOYAGER™ in direct sunlight.
3. If you are leaving your VOYAGER™ out in the sun for any amount of time, be aware that the heat can increase the
pressure inside the Pontoons to a dangerous level. Let some of the air out of the pontoons if the craft will be out
of the water in the sun for any length of time, or if it is stored in a vehicle, etc.
4. A gain in altitude will increase the pressure in the Pontoons also. If you are taking your inflated VOYAGER™ from a
low elevation to a high elevation, be sure to let some of the air out of it.
5. For short term storage, we recommend you let some air out of your pontoons.
6. For long term storage, we recommend you make sure your VOYAGER™ is completely dry, deflated and stored out of
the sunlight in a cool dry area.. Do not store your wet VOYAGER™ in freezing temperatures as this may result in
Frame and other component damage.
7. Repairing Bladder, use enclosed patch kit. Identify puncture. Fully deflate Bladder. Clean and dry area around
puncture. Apply glue to puncture area and patch using applicator straw. Press patch over puncture area. Allow
24 hours to dry, before inflating.
8. Note: Metal parts may rust and are not covered under warranty.
VOYAGER FRAMELESS PONTOON
WARNING:
Please read and follow carefully.
Care and Maintenance:
™