Ayra 9000-0004-6675 Podręcznik użytkownika - Strona 8
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Konwerter mediów Ayra 9000-0004-6675. Ayra 9000-0004-6675 10 stron. Dmx splitter / booster
Drukuj stronę
If you have any problems with DMX lighting, consult this troubleshooting section to solve any difficulties with
your product. If this troubleshooting section does not solve your problem, contact your dealer for more
information and help.
This troubleshooting section contains the most frequent problems and is not a complete collection of possible
faults, defects and solutions. The troubleshooting section applies for DMX controllers, DMX cabling and DMX
lighting fixtures. It is possible that not all described problems, causes and solutions apply to your situation as
product details may vary from product to product.
Problem
No DMX signal output
The fixture does not activate itself
The fixture does not respond to
DMX signals
Sometimes the DMX signal is lost
and/or some fixtures are
flickering / behaving odd
sometimes
Any information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 3.0
DMX lighting troubleshooting
Possible Cause
No power
No signal input, not connected or
no signal transmission.
Defects or faults in the signal
outputs of the device
Blown fuse
No power cable plugged in
Power switch is not in the ON
position
Wrong DMX address
DMX controller blackout function
activated
Faulty positioning of the DMX
polarity switch on the controller
No response or DMX activity
signal LEDs active
Faulty/broken DMX cables
Power cable interference on your
Creation date + author initials: 29-03-2014 RV Revision date + author initials: 27-05-2014 RV
Solution
Check the Power LED to see if the
fixture is active or not
Check if a DMX input is
connected. If connected, unplug
the cord and try to connect it
directly to a lighting fixture to see if
the DMX signal is OK. If so ,there
is something wrong with the unit or
signal distribution. If not, check
your DMX output.
Try another output and see if the
LEDs of the channel light up. If so,
connect a lighting device and try to
control it. If there is no result, try
another output or the DMX through
connection on the side of the unit.
Check the fuse compartiment for
blown fuses and replace it if
necessary.
Plug in the power supply to a
matching power outlet
Turn on the device by switching
the ON/OFF switch to the ON
position, if available
Set the DMX address to the right
value
Deactivate the blackout function of
your DMX controller
flip the polarity switch on your
DMX controller
Check your DMX cables for
possible connection breaks and
replace them if necessary.
Check your DMX cables for
possible connection breaks and
replace them if necessary.
Avoid installing the DMX and