Creo Trendsetter 400 Wizualna skrócona instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Wizualna skrócona instrukcja obsługi dla Drukarka Creo Trendsetter 400. Creo Trendsetter 400 9 stron.

Drukuj stronę
Removing a Flyoff
Trendsetter 400/800
!
1
The device suspends activity.
CAUTION: Wear protective
gloves when handling plates.*
CAUTION: If you have an
implanted cardiac pacemaker,
stay more than 7 cm away from
the magnetic clamps.*
3
Rotate the drum to expose
the trailing-edge clamps.
8
In Print Console, click Resume.
8
* Refer to the Operator Manual for full details.
2
4
Slide the trailing-edge
clamps off the plate.
9
Reposition the trailing-edge clamps:
a. Align the trailing-edge clamps with the
leading-edge clamps.
Open the front panel:
a. Rotate the two latches on the
front panel to the vertical position
(90° counterclockwise).
5
Fold over the corners
of the plate.
b. Ensure that the S or N (magnetic polarity)
on each clamp matches the S or N label on
the drum.
Trendsetter 400/800
b. Lift the front panel.
6
Press the leading-edge
7
clamps to free the plate.
The top access
panel opens by
itself.
Clean out any debris
left behind.
10
Close the front panel, then
close the top panel.
11
In Print Console, click Resume.