Digikeijs DR4088OPTO Instrukcja obsługi - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Jednostka sterująca Digikeijs DR4088OPTO. Digikeijs DR4088OPTO 15 stron. Feedback module
Również dla Digikeijs DR4088OPTO: Instrukcja obsługi (11 strony), Podręcznik (8 strony), Instrukcja obsługi (14 strony), Instrukcja obsługi (12 strony)
Drukuj stronę
DR4088LN-CS / GND / OPTO
3.3 Reset DR4088LN-xx
Important! The DR4088LN-xx has no function to reset to factory settings!
The DR4088LN-xx has no function for resetting to factory settings! This is also not necessary because no other functions can be set in the
DR4088LN-xx except the start address and the number of response addresses.
To reset the response address back to the basic setting 1, it is sufficient to send it again to the DR4088 LN-xx as described above. In the second
step, the number of feedbacks must be reset to 16 as described above. Further steps are not necessary.
4.0 Connection examples
In this chapter you will find some connection examples for the DR4088LN-xx. Please note that we are not able to show all possibilities that exist.
Important! DR4088LN-GND 3-wire operation DR4088LN-GND 3-wire operation:
Due to the H-bridge (track output) in the DR50xx, feedback devices in the DR4088LN-GND version must not be used against track ground, as is
usually the case with 3-wire tracks. This inevitably leads to the destruction of the DR50xx.
If a 3-wire driver still wants to drive with the DR5000 and report back against track ground, the DR4088OPTO
can be used.
www.digikeijs.com
® R-Bus, B-Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz
2021-04-21
P 10