Creo Medical 7-PG1-132 Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przełącznik Creo Medical 7-PG1-132. Creo Medical 7-PG1-132 8 stron. Footswitch

Connecting the Footswitch

The footswitch is connected to the footswitch connection socket on the rear panel of

the Electrosurgical Generator.

The Footswitch and the Electrosurgical Generator should be positioned such

that damage or accidental activation is avoided and that they do not present a

tripping hazard.

Please also refer to the manufacturer's instructions for use that are supplied

with the electrosurgical generator.

The Footswitch together with the Electrosurgical Generator require periodic preventive

maintenance every 12 months from the date of purchase. Servicing must only be

performed by Creo Medical personnel or their designated representative.

We recommend routine maintenance as follows:

• check enclosure and connecting cable for damage and destructive dirt;

• check functional elements and actuating elements for free operation.

Please also refer to the manufacturer's instructions for use that are supplied

with the electrosurgical generator.

Cleaning

The footswitch should be cleaned before and after each use in accordance with

procedures or other requirements of the hospital or other clinical site.

Caution

Switch off the electrosurgical generator before cleaning:

• for manual cleaning only, use just a cloth impregnated with water and a mild

detergent;

• do not use cleaning agents which may damage the plastic surfaces such as strong

detergents, abrasive cleansers or solvent-based cleaners (such as benzine, stain

remover);

• during cleaning, avoid wiping with a cloth under the pedal, because this may cause

the springs to move out of position.