Digilin Slot 25 Instrukcja instalacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt oświetleniowy Digilin Slot 25. Digilin Slot 25 2 stron. Led lighting profile
Drukuj stronęSlot 25 - LED Lighting Profile
Installation Guide
Installation
1.
Install mounting springs into profile. Approx
1 set per metre, minimum 2 per length.
a.
If necessary remove an end cap.
d.
Re-install the end (if removed)
4.
Run cable from drive gear to opening.
7.
Feed the profile (and power cable) into the
opening and allow the mounting spring to
pull the profile into place. Apply light
pressure if required.
c.
Feed the profile (and power cable) into
the opening and allow the mounting
spring to pull the profile into place.
Apply light pressure if required.
Note: Drivers should not be covered. Drivers rely on convection air flow for cooling and covering them may cause them to enter thermal regulation.
For any technical information relating to the connection of these luminaires to dimming systems, refer to LED products at
digilin.com.au
+617 3899 1267
b.
Slide the mounting spring into place in
the channel of the rear of the profile.
2.
Install drive gear and connect to power.
Leave power off. Drive gear will not fit
through opening cut for profile.
5.
Connect fitting to cable.
8.
Install subsequent lengths.
a.
Make interconnections between
lengths.
9.
Turn on power to the fitting.
c.
Lock the mounting spring in place by
tightening the grub screw.
3.
Cut an opening into the mounting surface to
match the profile dimensions.
6.
Press spring clips hard up (away from profile
body).
b.
Press spring clips hard up (away from
profile body).
www.digilin.com.au
Page 2 of 2