Cres Cor IFW 66 Series Instrukcje instalacji
Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Podgrzewacz do żywności Cres Cor IFW 66 Series. Cres Cor IFW 66 Series 2 stron. Infra red warmer
Drukuj stronę5925 Heisley Road • Mentor, OH 44060-1833
ELECTRICAL SPECS:
VOLTS WATTS AMPS
120
250
240
275
Warmer should be installed by an experienced
electrician.
U.L. REQUIREMENTS:
A. Wires of warmers to be connected to 75°C wire.
B. Wires are to be installed in conduit.
C. Warmers are not to be installed any closer than 1" from
a wall.
D. Warmers must be at least 16" above a combustible
surface.
HOW TO INSTALL:
Numbers in parentheses correspond to numbers in callouts.
1.
Remove the two screws from the canopy and pull off
the canopy.
2.
Run the cord (1) up through the canopy, through the
strain relief and the threaded nipple. Tighten the strain
relief. Cut the cord to the desired length.
3.
Mount the strap to the electrical outlet box with two
screws provided.
4.
Wire the warmer leads to the outlet box leads.
5.
Attach the ground wire to the ground hold in the strap
with the green ground screw.
6.
Re-attach the canopy with the two screws.
7.
Screw the bulb (4) into socket.
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
INSTALLATION INSTRUCTIONS
IFW 66 SERIES INFRA RED WARMER
HERTZ PHASE NEMA
2.0
60
1
1.1
60
1
5-15
6-15
Decorator Hood
FL-2194
IFW 66 Series
Rev. 5 (07/10)
Page 1 of 2