Digilock Curve Instrukcja obsługi produktu - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja obsługi produktu dla Czytnik kart Digilock Curve. Digilock Curve 8 stron. Keypad | basic & advanced
Również dla Digilock Curve: Instrukcja obsługi produktu (11 strony)
Drukuj stronę
SETUP
Locks are shipped with factory default settings (operates by presenting hand to lock). Each lock must be setup to operate with a
Programming Key and manager credentials (Manager Key or RFID credential).
1
Insert the Programming Key.
A two-tone beep will be heard
and the LED will flash.
PROGRAMMING INSTRUCTIONS
Express Register Manager Credentials
The Programming Key can quickly program the locks to operate with the same manager credentials.
1
Go to a lock already programmed to operate with the manager
credentials.
Insert and hold Programming Key in place for 10 seconds.
The LED will turn on and a two-tone beep will be heard after
5 seconds followed by two sets of two-tone beeps after 10
seconds.
3
Insert the Programming Key to program
each lock to operate with the same
manager credentials.
Two sets of two-tone beeps will be heard
and the LED will flash once to indicate
successful programming.
*The Programming Key will continue to function in express registration mode until it is used to operate the lock.
2
P R O DU CT GU I D E
Touch-Free RFID | Basic & Advanced
2
or
While the LED is flashing, insert
one Manager Key or present
one Manager RFID credential at
a time.
A two-tone beep will be heard
for each manager credential
programmed.
sec
4
End express registration mode.*
Go to any programmed lock and operate
it with the Programming Key.
Present hand to lock.
3
Insert the Programming Key.
A two-tone beep will be heard
and the LED will turn off.
2
Remove key and reinsert key.
Two sets of a two-tone confirmation beep will be heard and the
LED will turn off.
5
Then insert the Programming Key to
operate the lock.
4
Repeat preceding steps for
each lock or follow instructions
to Express Register Manager
Credentials to setup all the
locks.