Digimax 210 Podręcznik użytkownika - Strona 4
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Termostat Digimax 210. Digimax 210 11 stron. Programmable thermostat compatible with maxi controller
Również dla Digimax 210: Podręcznik użytkownika (12 strony)
Drukuj stronę4) Position
The ideal position to locate the DigiMax 210 is about 1.5m
above floor level, accessible, free from extremes of tem-
perature and draught. Do not mount it on an outside wall,
above a radiator or where it may be subjected to direct sun-
light.
The radio link does not mean that the wiring has been sim-
plified, but that the thermostat can be installed in any place of
your house to optimate your needs in heating.
We recommend you to make the installation with the Maxi
Controller before fixing your thermostat on the wall, in order
to be certain of its good operation at the selected place.
5) Fixing
1. The wall plate should be positionned with a minimum of
70 mm clearance all round to allow adequate air flow
2. Fix the wall-plate directly to a flat wall
3. Remove the battery insulation strip and check unit is func-
tioning, place it on its wall-plate
6) Configuring
The unit is supplied with a 5°C minimum temperature set
point and configured as a heating thermostat as factory de-
faults. Two internal links can be used to reconfigure these
defaults.
1. Open the unit by slackening the retaining screw situated
in the bottom edge and hinging carefully upwards. Dis-
engage the unit from the wall-plate and place it to one
side for safe keeping. Take off the batteries.
Page 4