Crescendo audio BC3500D Instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Crescendo audio BC3500D. Crescendo audio BC3500D 8 stron.
CONTROLS & CONNECTIONS
RCA INPUT & OUTPUT
RCA INPUT :
Connect preamp signal cables from
the source or the headunit to RCA input
RCA OUTPUT :
Output RCA jack to another amplifier.
GAIN ( 6V ~ 0.2V )
Matching the output voltage of
the headunit's
RCA line-outs to amplifier's input.
BASS BOOST ( 0 ~ 9dB )
The bass boost boosts frequency
centered at 45Hz.
LOW PASS FILTER ( 35~250HZ @24dB )
Controls the low pass filter frequency for
the speaker output.
MASTER / SLAVE ( STRAPPABLE )
Link connection makes 2 of same amplifiers linked to 2ohm
Set Output master / input slave switch to output master position for Master amp
which is connected to headunit.
Set Output master / input slave switch to input slave position for Slave amplifier
Connect RCA cable from RCA OUT at master amplifier to RCA IN at slave amplifier.
POWER & PROTECT LED
Blue-lit shows correct operation.
Red-lit shows general malfunction, faulty
connection, or thermal protection.
SUBSONIC FILTER ( 10~50HZ @ 24dB )
Control the high pass frequency for
the speaker outputs to eliminate
extreme low frequencies
REMOTE PORT
This port is for remote level control.
Plug remote control's connector for
remote level control's use.
Remote controls level from the driver's seat.
PHASE ( 0~180 DEGREE )
Controls phase 0~180 degrees for fine
tunning your low end staging in your
vehicle or fully switching polarity
if inverting your woofers.