Crescendo-Systems BUF2000 Podręcznik użytkownika - Strona 3
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Wzmacniacz Crescendo-Systems BUF2000. Crescendo-Systems BUF2000 6 stron. Video buffer amplifier with gamma
Drukuj stronę
Setup
In order to successfully use your BUF2000 in just follow the simple steps outlined below.
1. Make sure that your source device has the ability to correctly set the timing
needed by your display. If this is not the case, do not use the BUF2000.
2. Connect the component output of your source to the component input of the
BUF2000.
3. Connect the BUF2000 to your display using the VGA output connector.
4. Connect the power supply to the transcoder. Use only the supplied unit or an
exact equivalent.
Additional features
The BUF2000 is shipped in the following configuration:
• The horizontal and vertical sync are set to negative polarity with a horizontal sync
width of approximately 1μs
• The gamma control is set to just off
Normally the factory settings should work in most cases. If it does not, the sync features
mentioned above can be overruled manually. To do so the case has to be opened and
some switches changed. Before opening the case please remove the power supply
first. To open the case place a flathead screwdriver in one of the four slits on the side and
carefully twist to separate the two halves. To reach the switches on the bottom board
remove the top board by carefully pulling it up. On the bottom PCB is a switch block that
can be used to customize the various sync options of the BUF2000. A description of the
jumpers is given below.
BUF2000 users manual v1.0