Diginet LEDsmart MMDM/PB Instrukcja instalacji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Ściemniacz Diginet LEDsmart MMDM/PB. Diginet LEDsmart MMDM/PB 16 stron. Push button dimmer with built in on / off switch and multi-way control

Drukuj stronę

B: Setting Minimum Brightness

The minimum brightness level provided by the dimmer can be set to suit specific lamps and/or customer requirements.

For the majority of lamps a minimum level as low as 0% can be set if required. However, some lamps can become unstable at

low dimming levels, in particular CFL's.

If lamps become unstable at low dimming levels, they typically flicker or pulse on/off. The dimmer allows the minimum

brightness to be set to a level above the point at which the lamp flickers/pulses.

Step 1

Enter into the dimmer Setup Mode - See PART A (page 9)

Step 2

Click the dimmer push button twice

Step 3

LED will blink 2 times

Note: To cancel/exit do nothing for 30 seconds

Note: If more than one dimmer is connected to the same load (see pages 5-7), all

dimmers connected to this load will now blink 2 times

Step 4

Adjust dial to required MINIMUM brightness level

Note: If more than one dimmer is connected in parallel (see pages 5-7), wait for 3

seconds for the other connected dimmer to learn the new minimum level

Note: To cancel/exit do nothing for 30 seconds

Step 5

Click once to save & exit

Note: If more than one LEDsmart

brightness levels only needs to be set in one device. The setting is automatically

saved to all other devices connected in parallel

device is connected in parallel, the minimum

Push Button Dimmer/Switch