Diginet DGEMSR360P1 Instrukcja obsługi i instalacji - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Czujniki bezpieczeństwa Diginet DGEMSR360P1. Diginet DGEMSR360P1 16 stron. Recessed flush mount 360 pir presence sensor

Drukuj stronę

DIGINET ENERGY MANAGEMENT

5.3.

Sensor Head

The sensor head is designed to be installed in plasterboard ceiling or ceiling tiles with a thickness of 10mm -

16mm thickness. A 52mm diameter cut-out is required to recess mount the sensor head. Figure 5 shows a cross

section of the sensor head installation. A cut-out template is on the presence sensor box for ease of making the

cut-out.

Figure 5 – Installation cross section of sensor head installed in plasterboard ceiling or ceiling tile.

Note: Avoid placing the sensor in positions close to hot or cold air vents and where the field of view

extends through doorways. This will reduce the risk of false triggering of the sensor.

The sensor head should be connected to the control module prior to pushing into the ceiling cut-out. Using a

screw driver, lift the tab on the control module (refer to Figure 6) to expose the 5 pin connector for the sensor

head. Using the supplied 5 core cable with pre-terminated connector, plug the sensor head onto the connector

and close the tab, ensuring the cable is gripped properly. The sensor head cable length is 450mm and if required,

can be extended to a maximum length of 1 metre.

Figure 6 – Lift tab to connect the sensor head to the control module.

Diginet Control Systems Pty Ltd

Recessed Flush Mount 360

Minimum 10mm

plaster board

PIR Presence Sensor

Page 7 of 16