Cisco 2950 - Catalyst Switch Podręcznik - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik dla Przełącznik Cisco 2950 - Catalyst Switch. Cisco 2950 - Catalyst Switch 19 stron. Long-reach ethernet switches
Również dla Cisco 2950 - Catalyst Switch: Podręcznik rozwiązań (17 strony), Biuletyn produktu (3 strony), Biuletyn wsparcia produktu (5 strony), Podręcznik migracji (25 strony), Biuletyn wsparcia produktu (6 strony), Podręcznik dla początkujących (29 strony), Arkusz danych (20 strony)

Drukuj stronę
Cisco 2950 - Catalyst Switch Podręcznik
Cisco - Connecting a Terminal to the Console Port on Catalyst Switches
Connecting a Terminal to Catalyst 2948G-L3,
4908G-L3, and 4840G Series Switches
You may configure the Catalyst switch routers from a direct console connection to the console port or
remotely through its management port.
Use the RJ-45-to-RJ-45 rollover cable and RJ-45-to-DB-9 female data terminal equipment (DTE)
adapter (labeled "Terminal") to connect the console port to a PC running terminal emulation
software.
If you are using a direct console connection, configure your terminal emulation program for 9600
baud, 8 data bits, no parity, and 1 stop bit.

Console Port Pinouts

The console port is an RJ-45 receptacle. Data Terminal Ready (DTR) and Data Set Ready (DSR)
handshake signals are supported. The Request To Send (RTS) signal tracks the state of the Clear To Send
(CTS) signal.
Table B-1
Table B-1: Console Port Pinouts
Pin
Signal
Direction
1¹
RTS/CTS Output
2
DTR
Output
3
TxD
Output
4
SGND
5
SGND
6
RxD
Input
7
DSR
Input
8¹
RTS/CTS Input
¹Pin 1 and pin 8 are connected.
Connecting a Terminal to Catalyst 2926 and 2926G
Series Switches
On the Catalyst 2926 series switch, the console port is located on the Supervisor Engine front panel and
is labeled "CONSOLE," as shown in the figure below.
Figure: Console Port Connector (Catalyst 2926 Series Switch)
http://www.cisco.com/warp/public/473/9.html (5 of 19) [9/4/2003 12:36:02 PM]
lists pinouts for the console port.
Description
Request To Send / Clear To
Send
Data Terminal Ready
Transmit Eata
Signal Ground
Signal Ground
Receive Data
Data Set Ready
Request To Send / Clear To
Send