Cisco 2960 8TC - Catalyst Switch Podręcznik dla początkujących - Strona 14
Przeglądaj online lub pobierz pdf Podręcznik dla początkujących dla Przełącznik Cisco 2960 8TC - Catalyst Switch. Cisco 2960 8TC - Catalyst Switch 23 stron. 8-port switches
Drukuj stronę
6
Connecting to the Switch Ports
This section describes how to connect to the switch ports, the SFP module ports, and to the
dual-purpose ports. For additional cabling information, see the Catalyst 2960 Switch Hardware
Installation Guide on Cisco.com.
Connect to the 10/100 and 10/100/1000 Ports
Follow these steps:
When you connect to servers, workstations,
Step 1
IP phones, wireless access points, and
routers, insert a straight-through, twisted
four-pair, Category 5 cable in a switch
10/100 or 10/100/1000 port. Use a
crossover, twisted four-pair, Category 5 cable
when you connect to other switches, hubs, or
repeaters.
Step 2
Insert the other cable end into an RJ-45 connector on the other device.
For simplified cabling, the automatic medium-dependent interface crossover (auto-MDIX) feature is
enabled by default on the switch. With auto-MDIX enabled, the switch detects the required cable type
for copper Ethernet connections and configures the interfaces accordingly. Therefore, you can use
either a crossover or a straight-through cable for connections to a switch 10/100 or 10/100/1000
Ethernet port, regardless of the type of device on the other end of the connection.
14
SY ST
ST AT
C O N S O
L E
DP LX
1 x
2 x
SP D
1
2
3
4
M OD E
10/100 or 10/100/1000 ports