BYECOLD HH0606L Instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Grzałka BYECOLD HH0606L. BYECOLD HH0606L 10 stron. Infrared heater panel with led light
5
Make sure the Programming function has been switched to ON by long press
MODE setting if you want to use any programming mode.
6
Do not cover or touch the temperature sensor which is at the top of the
thermostat.
7
Do put the thermostat in a open normal room environment rather not inside a
drawer/pocket or under pillow/quilt etc.
Please do take out the batteries from the thermostat if long time no use.
8┃TROUBLESHOOTING
Problem
It has noise when original
Due to the structure
charged with electricity
stress of the heat
insulator.
The surface of the device
Due to the thermal
was slightly raised.
expansion of the surface
material.
The surface of the
1. The voltage is low.
heating device is slightly
2. In a low-temperature
warm.
environment.
9┃MAINTENANCE & SERVICING
Activities required before starting maintenance
Warning of electrical voltage
• If the power cord comes without plug, disconnect the circuit before
connecting it.
• Do not touch the mains plug or power cord connection with wet
or damp hands.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• Allow the device to cool down completely.
Reason
Measure
It is a normal
phenomenon.
Don't worry about it.
It is a normal
phenomenon.
Don't worry about it.
1. Install a voltage
regulator.
2. It is normal.
Warning of electrical voltage
Tasks which require the housing to be opened must only be carried
out by authorized specialist companies.
Cleaning the device
Warning of electrical voltage
Never immerse the device in water!
Clean the device with a soft, damp and lint-free cloth.
Ensure that no moisture enters the housing. Protect electrical
components from moisture. Do not use any aggressive cleaning
agents such as cleaning sprays, solvents, alcohol-based or
abrasive cleaners to dampen the cloth.
Wipe the housing dry after cleaning
10┃STORAGE
When the device is not being used, observe the following storage conditions:
• dry and protected from frost and heat
• in an upright position where it is protected from dust and direct sunlight
• with a cover to protect it from invasive dust, if necessary
• Place no further devices or objects on top of the device to
prevent it from being damaged.
- 7 -
EN