Cisco 4900M - Catalyst Switch Instrukcja instalacji - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przełącznik Cisco 4900M - Catalyst Switch. Cisco 4900M - Catalyst Switch 8 stron. 10/100base-t
Również dla Cisco 4900M - Catalyst Switch: Instrukcja rozwiązywania problemów (6 strony)
Drukuj stronę
Pre-Installation Software Commands
Catalyst 10/100Base-T Ethernet Hub Upgrade
Follow these software instructions before installing the 10/100Base-T
ethernet hub.
1) While in IMAGE, type halt_tst and confirm by typing Y
2) Login as root
3) Type csh
4) Type source/image/common/.login
5) Type cd/etc
6) For SPARC5 type:
•
rm hostname.le0
•
vi hostname.hme0
Change hostname-gate to hostname
•
Example: for hostname.hme0, file was bay5-gate. Change to bay5
7) For Ultra 1 type rm hostname.hme1
8) Type vi hosts and remove the line listing gateway IP and name.
For example, remove 131.101.175.161 bay8-gate
9) Type cd
If changing IP addresses, continue with step 10. Otherwise, skip to step 12.
10) Type /image/bin.rls/custom/change_sys_name
11) Run change_sys_name script and change IP addresses.
12) Type tip
hardwire and press Return after display reads
connected.
13) Login to test computer as root
14) Type cd/etc
15) Type mv hostname.le0 hostname.hme0
16) Type ~#
17) At the OK prompt, type setenv boot-device net2
This is necessary because the 10Base-T ethernet connection to port 1 on
the test computer moves to port 2 for 100Base-T operation.
18) Open new command tool window.
19) Login as root
20) Type cd/var/yp; /usr/ccs/bin/make
21) Type halt_sys
22) Shut the test system down and perform the hardware upgrade.
3