Cisco 4900M - Catalyst Switch Instrukcja rozwiązywania problemów - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja rozwiązywania problemów dla Przełącznik Cisco 4900M - Catalyst Switch. Cisco 4900M - Catalyst Switch 6 stron. 10/100base-t
Również dla Cisco 4900M - Catalyst Switch: Instrukcja instalacji (8 strony)
Drukuj stronę
Chapter 1
Troubleshooting the Installation
Table 1-1
LED
INPUT OK (AC)
INPUT OK (DC)
OUTPUT OK
Verify that the LEDs on the front panel are lit:
Step 2
The STATUS LED flashes yellow during diagnostic boot tests. It is green when the switch is
•
operational (online). If the system software is unable to start up, this LED stays orange.
The port LEDs (1-48) are green when the module is operational (online). If no signal is detected,
•
the LINK LED is off. The port LED remains yellow if the port is disabled. The port LED flashes
yellow if the port tested faulty at startup.
If a STATUS LED is red, contact a customer service representative for instructions.
Step 3
If the boot information and system banner are not displayed, verify that the terminal is set correctly and
Step 4
that it is connected properly to the console port.
78-18350-02
Power Supply LED Meanings
Meaning
This LED should turn green immediately when power is
applied to the supply and the power switch is set to ON.
Green—AC input voltage is greater than 80.5 VAC
±4.5 VAC.
Red—In a dual power supply configuration (alternate unit
powered) the AC input is less than 73 VAC ±3 VAC, or the
power supply is turned off.
Off—In a single supply configuration, signals that AC
input voltage is less than 73 VAC ±3 VAC, or the power
supply is turned off.
This LED should turn green immediately when power is
applied to the supply.
Green—DC input voltage is greater than –38.25 VDC
±2.25 VDC.
Red—In a dual power supply configuration (alternate unit
powered) the DC input is less than 33 VDC ±3 VDC, or the
power supply is turned off.
Off—In a single supply configuration, the LED shall be off
to signal that DC input is less than 33 VDC ±3 VDC, or the
power supply is turned off.
Green—DC output voltages are within the normal
operating range.
Red—Output voltages below the minimum or above the
maximum will create an output fail alarm and cause the
LED to illuminate red.
Identifying Startup Problems
Cisco Catalyst 4900M Switch Installation Guide
1-3