Cisco 500 Series Quick Start Quide - Strona 8

Przeglądaj online lub pobierz pdf Quick Start Quide dla Przełącznik Cisco 500 Series. Cisco 500 Series 13 stron. Stackable managed switches
Również dla Cisco 500 Series: Podręcznik z informacjami dotyczącymi bezpieczeństwa (42 strony), Podręcznik (4 strony), Skrócona instrukcja obsługi (21 strony), Arkusz danych (5 strony), Podręcznik użytkownika (4 strony), Podręcznik użytkownika (6 strony), Podręcznik użytkownika (46 strony), Podręcznik (40 strony), Podręcznik administracyjny (48 strony), Podręcznik (24 strony), Rozwiązywanie problemów i konserwacja (15 strony), Skrócona instrukcja obsługi (7 strony), Skrócona instrukcja obsługi (25 strony)

Drukuj stronę
Cisco 500 Series Quick Start Quide
Follow the Setup Wizard instructions to finish the WAP device
S
7
TEP
installation. We strongly recommend you use the Setup Wizard for
the first installation.The Setup Wizard turns on the Wi-Fi radio,
allowing you to connect wirelessly. For more advanced
configurations, see the Administration Guide. A link to the
Administration Guide is found in
page
11.
Congratulations, you can now start using your wireless access point.

Suggested Next Steps

7
In case of an error while installing, try the following troubleshooting
procedures:

Troubleshooting

If you cannot display the configuration utility, you can test the ability of the
computer to communicate with the device by using ping. To use ping on a
computer running Windows:
Verify that the Cisco WAP551 or WAP561 is powered on and the
S
1
TEP
lights indicate the appropriate links.
Locate the device's IP address. While there are different ways to
S
2
TEP
locate your device's IP address, this procedure uses Cisco FindIT.
a.
If you have previously downloaded Cisco FindIT, open Internet
Explorer and launch Cisco FindIT. For more information on
downloading Cisco FindIT, see www.cisco.com/go/findit.
b. In the Cisco FindIT display, place your mouse over the device's
name. The device IP address is displayed along with other
device information.
Open a command window by using Start > Run and enter cmd.
S
3
TEP
At the Command window prompt enter ping and the device IP
S
4
TEP
address. In this example, we pinged 192.0.2.10.
If successful, you should get a reply similar to the following:
Pinging 192.0.2.10 with 32 bytes of data:
Reply from 192.0.2.10: bytes=32 time<1ms TTL=128
8
Cisco Small Business WAP500 Series Wireless Access Point
"Where to Go From Here" on