Cisco 9000 Series Instalacja - Strona 2

Przeglądaj online lub pobierz pdf Instalacja dla Przełącznik Cisco 9000 Series. Cisco 9000 Series 19 stron.

Drukuj stronę

Shelf-Installation Guidelines

Note
This section describes the procedure for installing a switch in a rack or cabinet using the optional Telco and
EIA Shelf Bracket Kit.
Shelf-Installation Guidelines
Caution

Before Installing the Shelf Brackets

Before installing the shelf brackets, inspect the contents of your kit. The following table lists the contents of
the shelf bracket kit:
Quantity
2
2
1
2
16
16
Required Equipment
You need the following equipment for this installation:
• Number 2 Phillips screwdriver
• Tape measure and level (to ensure that shelf brackets are at level with each other)
Installing the Shelf Bracket Kit into a Four-Post EIA Rack
The following figure shows the installation of the shelf bracket kit into a four-post EIA rack:
Installing the Cisco MDS 9148V-K9 Switch
2
Telco and EIA Shelf Bracket optional kit is not provided with the switch; to order the kit, contact your switch
supplier.
• If the rack is on wheels, ensure that the brakes are engaged or the rack is otherwise stabilized.
• If you are installing this kit in an EIA rack, attach the shelf to all four rack-mounting posts; the EIA posts
may not be thick enough to prevent flexing of shelf brackets if only two posts are used.
Installing the Cisco MDS 9148V-K9 Switch
Part Description
Slider brackets
Shelf brackets
Crossbar
10-32 x 3/8-in. Phillips pan-head screws
12-24 x 3/4-in. Phillips screws
10-24 x 3/4-in. Phillips screws