Cisco Aironet 350 Series Podręcznik - Strona 4

Przeglądaj online lub pobierz pdf Podręcznik dla Przełącznik Cisco Aironet 350 Series. Cisco Aironet 350 Series 10 stron. Managed switches
Również dla Cisco Aironet 350 Series: Skrócona instrukcja obsługi (12 strony), Informacje o wersji (14 strony), Skrócona instrukcja obsługi (16 strony), Skrócona instrukcja obsługi (12 strony), Skrócona instrukcja obsługi (12 strony), Skrócona instrukcja obsługi (2 strony), Poznaj (16 strony), Skrócona instrukcja obsługi (5 strony)

You have now connected your switches according to your desired topology.

Configure Stack Settings on the Active Switch

Active Switch Selection Process

The active unit is selected from the active-enabled units (1 or 2). The factors in selecting the active

unit are taken into account in the following priority:

System Up Time - The active-enabled units exchange up-time, which is measured in

segments of 10 minutes. The unit with the higher number of segments is selected. If both units

have the same number of time segments, and the unit ID of one of the units was set manually

while the unit ID of the other was set automatically, the unit with the manually-defined unit ID

is selected; otherwise the unit with the lowest unit ID is selected. If both units IDs are the

same, the unit with the lowest Media Access Control (MAC) address is chosen.

The up time of the Standby unit is retained when it is selected as active in the switch failover

process.

Unit ID - If both units have the same number of time segments, the unit with the lowest unit ID

is selected.

MAC Address - If both units IDs are the same, the unit with the lowest MAC address is

chosen.

For a stack to operate, it must have an active unit. An active unit is defined as the Active unit that

assumes the active role. The stack must contain a Unit 1 and/or Unit 2 after the active selection

process. Otherwise, the stack and all its units are partially shut down, not as a complete power-off,

but with traffic-passing capabilities halted.

Follow these steps to configure stack settings on the Active switch:

Step 1

have configured a new username or password, enter the credentials instead.