S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
then follow the upgrade guidelines listed in the
section on page
VSANs.
To upgrade from Cisco SAN-OS Releases 2.1(1a), 2.1(1b), or 2.1(2a) to Release 2.1(2b) for all other
VSANs with IVR enabled, follow these steps:
Configure static domains for all switches in all VSANs where IVR is enabled. Configure the static
Step 1
domain the same as the running domain so that there is no change in domain IDs. Make sure that all
domains are unique across all of the IVR VSANs. We recommend this step as a best practice for
IVR-non-NAT mode. Issue the fcdomain domain id static vsan vsan id command to configure the static
domains.
Note
Issue the no ivr virtual-fcdomain-add vsan-ranges vsan-range command to disable RDI mode on all
Step 2
IVR enabled switches. The range of values for a VSAN ID is 1 to 4093. This can cause traffic disruption.
Note
Check the syslogs for any ISL that was isolated.
Step 3
2005 Aug 31 21:52:04 switch %FCDOMAIN-2-EPORT_ISOLATED:
%$VSAN 2005%$ Isolation of interface
port-channel 52 (reason: unknown failure)
2005 Aug 31 21:52:04 switch %FCDOMAIN-2-EPORT_ISOLATED: %$VSAN 2005%$
Isolation of interface port-channel 51
(reason: domain ID assignment failure)
Issue the following commands for the isolated switches in Step 3:
Step 4
switch(config)# vsan database
switch(config-vsan-db)# vsan vsan-id suspend
switch(config-vsan-db)# no vsan vsan-id suspend
Issue the ivr refresh command to perform an IVR refresh on all the IVR enabled switches.
Step 5
Issue the copy running-config startup-config command to save the RDI mode in the startup
Step 6
configuration on all of the switches.
Follow the normal upgrade guidelines for Release 2.1(2b). If you are adding new switches running Cisco
Step 7
MDS SAN-OS Release 2.1(2b) or later, upgrade all of your existing switches to Cisco SAN-OS Release
2.1(2b) as described in this workaround. Then follow the normal upgrade guidelines for Release 3.2(1).
Note
Reconfiguring SSM Ports Before Upgrading to SAN-OS Release 3.2(1)
Starting with Cisco MDS SAN-OS Release 3.0(1), the SSM front panel ports can no longer be configured
in auto mode, which is the default for releases prior to Release 3.0(1).
OL-14116-01
11. If you have VSANs in interop mode 2 or 3, you must issue an IVR refresh for those
Complete Step 1 for all switches before moving to Step 2.
Complete Step 2 for all IVR enabled switches before moving to Step 3.
RDI mode should not be disabled for VSANs running in interop mode 2 or interop mode 3.
Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.2(1)
Upgrading Your Cisco MDS SAN-OS Software Image
"Upgrading Your Version of Cisco Fabric Manager"
17
Drukuj stronę