Accustic Arts CD-PLAYER I (MK 3) Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odtwarzacz CD Accustic Arts CD-PLAYER I (MK 3). Accustic Arts CD-PLAYER I (MK 3) 14 stron.
Również dla Accustic Arts CD-PLAYER I (MK 3): Instrukcja obsługi (10 strony)

Drukuj stronę

6.6.7 A / B

The A / B function is also a repeat mode. You can use this key to repeat a certain passage of the track.

The A / B repeat mode is operated as follows:

1. During CD playback press the A / B key on the remote control just as the required passage begins

(start point A). In the display A – now appears.

2. When the end of the passage is reached (end point B), press the A / B key again and on the display

A – B now appears.

The device now plays the marked passage between points A and B again and again.

Pressing the A / B key again deactivates the repeat mode.

6.7 Dimmer function of blue LEDs

The two blue LEDs for STANDBY and OPERATE have an integrated dimmer function. That means the

LEDs will be automatically adapt to the brightness of your room.

7 Looking after your equipment

The CD-PLAYER I (MK 3) from ACCUSTIC ARTS

usual care taken with high quality devices. Clean the housing with a dry or slightly moistened cloth.

Please do not use any aggressive detergents or detergents which contain silicon.

The best way to clean the front plate is with a mild non-aggressive fat-dissolving detergent (e.g. glass

cleaner). Never use abrasive agents or polishing agents with abrasive particles.

CAUTION!

Do not place the unit in direct sunshine and avoid extreme changes in temperature.

8 Troubleshooting

Malfunctions are mostly caused by something simple which can be put right quickly.

In the next section some possible malfunctions are described together with their corrective action.

However, if it is not possible to remove the malfunction please contact your authorised dealer.

The unit was switched on, the blue LED 9 remains dark.

Malfunction

Cause 1

The mains cable is not properly connected.

Solution

Check mains cable and push in firmly.

Cause 2

The fuse is damaged.

Solution

Pull out all mains plugs and replace the corresponding fuse (see chapter 5.5).

Malfunction

The unit was switched on. The laser initialises, but shows

The CD loader cover 13 was not properly closed during the switching on process.

Cause 1

Solution

Close CD loader cover; laser unit always initialises after each closing process.

does not require special treatment in excess of the

OPEN