Cisco Catalyst 2960-S Series Uruchomiona instrukcja obsługi - Strona 13
Przeglądaj online lub pobierz pdf Uruchomiona instrukcja obsługi dla Przełącznik Cisco Catalyst 2960-S Series. Cisco Catalyst 2960-S Series 31 stron. Switch getting
Również dla Cisco Catalyst 2960-S Series: Arkusz danych (28 strony), Instrukcja instalacji (27 strony)
Drukuj stronę
Catalyst 2960-S Switch Getting Started Guide
Switch Console Port
Switch Ethernet Management Port
Switch USB Port
OL-19793-02
Connect the supplied RJ-45-to-DB-9 adapter cable to the standard 9-pin
1.
serial port on the PC. Connect the other end of the cable to the console port
on the switch.
Start a terminal-emulation program on the PC.
2.
Configure the PC terminal emulation software for 9600 baud, 8 data bits, no
3.
parity, 1 stop bit, and no flow control.
Use the CLI to enter commands to configure the switch. See the software
4.
configuration guide and the command reference for more information.
Connect a Category 5 Ethernet cable to the PC Ethernet port. Connect the
1.
other end of the cable to the Ethernet management port on the switch.
Start a Telnet session on the PC.
2.
Enter the switch IP address that you assigned by using Express Setup.
3.
4.
Use the CLI to enter commands to configure the switch. See the software
configuration guide and the command reference for more information.
Connect an USB cable to the PC USB port. Connect the other end of the cable
1.
to the mini B (5-pin-connector) USB port on the switch.
Start a terminal-emulation program on the PC.
2.
Configure the PC terminal emulation software for 9600 baud, 8 data bits, no
3.
parity, 1 stop bit, and no flow control.
Use the CLI to enter commands to configure the switch. See the software
4.
configuration guide and the command reference for more information.
You cannot use the switch console port and the switch USB port at the
Note
same time to access the CLI.
Catalyst 2960-S Switch Getting Started Guide
13