Accutach GM Steering Wheel Button Box Instrukcja instalacji

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria samochodowe Accutach GM Steering Wheel Button Box. Accutach GM Steering Wheel Button Box 19 stron.

Drukuj stronę

GM Steering Wheel Button Box

Installation Guide

Rev. 1.0

www.accutach.com

Thank you for purchasing the Accutach Co. General Motors Steering Wheel Button Box. It is designed to allow you

to repurpose the audio and/or cruise control buttons on your stock GM steering wheel to control other accessories.

Supported GM cars include: 1997-2001 Camaro, 1995-2002 Firebird, 2007-2013 Corvettes, 2010-2015 Camaros

and other GM cars, trucks and SUVs of those vintages. See the list of known compatible cars in the following

sections of this document. This box may be compatible with other models of GM vehicles.

WARNINGS and DISCLAIMERS:

You use this product at your own risk. Accutach Company is not responsible for personal injury or property damage

through the use of this product. While it is possible to use a switch in the steering wheel control wire to switch the

steering wheel button function from radio/cruise control to accessory control and back again, Accutach Company

strongly recommends that users permanently change the button functions from radio/cruise control to control of your

accessory. If you choose to use a switch against our recommendations be careful make sure you know how the

switch is set prior to pressing any steering wheel button. You'd hate to activate a line lock at road speeds while

trying to adjust the radio.

Do not touch the air bag wiring as you modify the radio control wiring near the steering column. Make sure you

disconnect the battery before doing any electrical work described in this installation guide and follow the air bag

safety recommendations in the GM shop manual.

We strongly recommend making wire connections with solder & shrink tubing, although properly made crimp splices

can also be reliable. We do not recommend using "Scotch Lock" style connections for our products. Do not use the

"twist & tape" method of connecting wires.

Before you begin:

You will need to identify a switched battery voltage power supply wire to splice into for power for the Corvette

Steering Wheel Button Box, and you will need a good chassis ground to ground the unit.

You will also need to locate a suitable place to install the unit inside of the vehicle's cabin, most likely under the

dash or in the console near the shifter. It is not intended for use in the engine compartment or anywhere outside of

the cabin. If you wish to create a custom mounting bracket out of ABS plastic you can glue it to the ABS box with

standard ABS cement from a hardware store.

Page 1