Sharp Carousel II R-1821 Instrukcja obsługi - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kuchenka mikrofalowa Sharp Carousel II R-1821. Sharp Carousel II R-1821 32 stron. Over the range convection microwave oven
Operation
of Auto-Touch ® Control Panel
Your new Sharp Auto-Touch convection microwave oven uses a microp_,
the electronic brain that provides
a wide variety of cooking programs which could not be achieved by _tional
cont.01 methods. The operation
of the oven is controlled by touching the appropriate pads arranged on l_
surface of the corm'ol panel.
An entry signal tone should be heard each time you touch the control panel to make a correct entry. If you do not
hear this sound:
I)
You have not used enough pressure in touching the pad.
2) You have made more entries than the control panel will accept.
3) You have made an incorrect entry.
In addition to the ent-- D, signal tone, an audible signal will sound for approximately 2 seconds at the end of the cooking
cycle.
After cooking or using the minute timer, the time of day will appear on the display.
"/',,take. sure the oven is_
into a 3-pronged 115-120 volt household o.,'tlet. When the oven is plugged in,
the display will show _,
flashing on and off each second. Touch the STOP/CLEARpad: _
will appear°
* You cannot program the o,_n if the door is not closed fimlly_
'_ This oven can be programmed for up to 4 automatic sequence& (EX.: Microwave !v'ed - Microwave High - Pause
- High Mix RoasO
* During cooking, the program cannot be changed until the STOPICLEAR pad is touched twice. All functions are
locked in to prevent accidental changes.
" During cooking, when the door is opened, the cooking time in the readout automatically stops. The cooking
time starts to count down again when the door is closed and the START pad is touched.
* I! the electrical power to your microwave oven is interrupted, the display will intermittently show _
after
the power is reinstated. If this occurs during cooking, the program will be erased° Simply reset the_or
the
correct time of day and reprogram.
[ To Set the Clock ]
* Suppose you want to enter the correct time of day 12:30 (A.M. or PoM.)
NOTE: 1o "[his
,
[Step I
2,1
_ 3, I
Procedure
Touch _e AUTO
START/CLOCK
pad°
Enter the correct time of day by touch-
ing the nurr_rs
in sequer'_eo
Touch AUTO START/CLOCK pad again_
Pad Order
ct£r_
[ _ii_
SrANr 1
is a 12 hour clock. _
will appear in the readout i_ttempt
to enter an incorrect clock
t_me.. For example, if you try to en_r 8:6! or 13:00, [ /_RRORI and tie incorrect clock time will
appear repeatedly° To erase 1.. E RROR l, touch the STOP/CLEAR pad. tfyou accidently ouch more
than 4 number pads, the last 4 numbers you have touct-_
will appear on the display,
If the oven is in cooking or minute timer mode and you wish to know the time of day, simply touch the
AUTO STARTiCLC__Kpad_ As long as your finger is touching the pad, tie time wilt be displayed.
This checking operation does not interfere with the cooking time, oven temperature, or minute
timer.
9