Sharp Carousel R-1514 Instrukcja instalacji - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Kuchenka mikrofalowa Sharp Carousel R-1514. Sharp Carousel R-1514 9 stron. Over the range stainless
Również dla Sharp Carousel R-1514: Broszura i specyfikacje (8 strony), Instrukcja instalacji (40 strony), Podręcznik gotowania (32 strony), Broszura i specyfikacje (5 strony), Specyfikacje (2 strony), Dodatkowa instrukcja serwisowa (33 strony), Podręcznik gotowania (32 strony), Podręcznik (40 strony), Dodatkowa instrukcja serwisowa (33 strony)

OVEN INSTALLATION

THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUCTIONS FOUND ON

BOTH TEMPLATES.

THE NEXT STEP IS TO READ AND FOLLOW MOUNTING INFORMATION ON BOTH TOP CABINET AND WALL TEMPLATES.

NOTE: THIS OVEN SHOULD BE ATTACHED TO AT LEAST ONE WALL STUD. See WALL CONSTRUCTION on page 1.

MOUNTING SCALE PLATE

Attached 2 Scale Plates !, with tape (not included). See Figure 16 and WALL TEMPLATE for locations.

MOUNTING PLATE

1. Separate 4 Toggle Bolts 2, packed in the INSTALLATION HARDWARE, from the Toggle Nuts.

2. Match 5/8" holes (not in stud/s), drilled through WALL TEMPLATE into wall to corresponding holes on Mounting Plate.

3. Insert Toggle Bolts into matched openings on Mounting Plate. Put Toggle Nuts on Toggle Bolts. See Figure 17.

4. Position the Mounting Plate with the Toggle Bolts attached at the wall location and insert Toggle Nuts and Bolts through the

holes in the wall with the Toggle Nuts closed. Figure 18. Use Wood Screws 1 to attach the Mounting Plate to studs.

NOTE: Before insertion, be sure you leave a space more than the thickness of the wall between the Mounting Plate and the end

of each of the Toggle Nuts (in the closed position). If you do not leave enough space, the Toggle Nut will not be able to open on

the other side of the wall. Also, once a Toggle Nut opens, it cannot be withdrawn from the hole; therefore make sure all

of the Toggles are in the correct position before insertion.

4. Align the Mounting Plate carefully and hold in position while tightening Toggle Bolts. Pull Toggle Bolt toward you and turn

clockwise to tighten. Figure 19.

Figure 17

Mounting

Plate

Figure 16

Mounting Plate

Figure 18

Scale Plates

Space more than

wall thickness

Wall

Figure 19