Sharp Carousel R-880F Instrukcja serwisowa - Strona 21
Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Kuchenka mikrofalowa Sharp Carousel R-880F. Sharp Carousel R-880F 48 stron. Double grill convection microwave oven
Również dla Sharp Carousel R-880F: Instrukcja serwisowa (3 strony)
Drukuj stronę
PROCEDURE
LETTER
6-2. Place the container on the center of tray in the oven cavity.
6-3. Close the door.
6-4. Touch Fresh Vegetables pad.
6-5. The control panel is in automatic Sensor operation.
6-6. The display will start to count down the remaining cooking time, and the oven will turn off
automatically after the water is boiling (babbling).
If new sensor dose not operate properly, the problem is with the control unit.
(1) Disconnect oven from power supply and then remove outer case.
(2) Discharge the high voltage capacitor.
(3) Disconnect the wire leads from the cook relay.
(4) Disconnect the sensor connector that is mounted to lower portion of control panel.
(5) Then connect the dummy resistor circuit (see fig.) to the sensor connector of control panel.
(6) Reconnect the oven to the power supply and check the sensor cook operation, proceed as follows:
6-1. Touch Fresh Vegetables pad.
6-2. The control panel is in the sensor cooking operation.
6-3. After approximately 1 minute and 15 seconds, push plunger of select switch. This condition
is same as judgement by AH sensor.
6-4. After approximately 3 seconds, the oven stops.
If the above is not the case, the control unit is probably defective.
If the above is proper, the AH sensor is probably defective.
TEST PROCEDURES
COMPONENT TEST
CHECKING CONTROL UNIT
R1,R2 : 22
R3 : 4.3k
R4 : 1M
To connector (F)
on Control Unit.
1
F-1
2
F-2
3
F-3
CONNECTOR
Sensor Dummy Resistor Circuit
19
1% 1/2W
5% 1/4W
5% 1/4W
COM NO
R1
R3
R4
R2
R-880F(S)
Plunger
NC
NO
COM
NC