Crestron TMK-12L Instrukcja instalacji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Stojaki i stojaki Crestron TMK-12L. Crestron TMK-12L 16 stron. Trim ring mount kits
Również dla Crestron TMK-12L: Instrukcja instalacji (12 strony)

Drukuj stronę

Trim Ring Mount Kits

6 • Trim Ring Mount Kits: TMK-12L & WMKT-12L

TPS-12L Mounting Using the TMK-12L – Exploded View

TRIM RING

(2013001)

TPS-12L

(Bezel Removed)

(Bezel)

WMKT-12L Procedure

This section provides the necessary steps for the assembly and installation of the

WMKT-12L into a wall. Review the procedure first, then complete the steps in the

order provided. The only tools or materials required and not supplied are a drywall

saw or equivalent and a level.

CAUTION: Allow an air gap of at least 12 inches (30.48 cm) in the wall cavity

above and below the touchpanel for heat dissipation.

Locate an area on the wall that is free of miscellaneous wiring and studs.

Make a small hole near the middle of the designated site; verify that the

location is suitable.

NOTE: Make the cutout as level and smooth as possible. The mounting plate allows

for only minor leveling adjustments. If a larger cutout is made accidentally, consider

purchasing the Crestron Mud Mount Kit, MMK-12L. Together with the mounting

plate supplied with the WMKT-12L, it provides a cost-effective means of correction.

Essentially, the combination of these two kits makes up the Crestron Mud Mount Kit

for the wall, WMKM-12L. Simply follow the "WMKM-12L Procedure" in the latest

revision of the Mud Mount Kits Installation Guide (Doc. 6359).

3. Use the drywall saw or equivalent and the provided drywall cutout template

to produce an accurate, clean and level cutout in the drywall.

Crestron TMK-12L & WMKT-12L

PMK-12L

DRYWALL

MOUNTING SCREWS (8)

#06-32 X 1-1/2" (2007254)

NOTE: MOUNTING SCREWS

SUPPLIED WITH TOUCHPANEL.

Installation Guide – DOC. 6360A