DIGISYSTEM DSD-200D Instrukcja obsługi

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt laboratoryjny DIGISYSTEM DSD-200D. DIGISYSTEM DSD-200D 3 stron. Dry bath

Warnings:

* The surface is hot. Do not touch.

* Do not put any objects on the top of the instrument.

* Please keep the environment ventilated.

* The instrument should be placed in a low relative humidity and low dust place away from water source.

1. Connect with power supply. Please make sure the power voltage is the same as the voltage shown on the

label stuck on the back of machine.

2. Press "ON/OFF Button", then you will see the "Power indicator' becomes green. Wait for about 5 seconds;

you can see that on the display screen, the top row is the present temperature value (PV) and the bottom

row is the setting temperature value (SV).

3. Set temperature: you will see

enter the value.

4. Set time: Select time mode: Continouos mode

4.1 Press

to set Continuous mode. OUT2 indicator on display screen will disappear. The

setting is finished. Go to Step 6.

4.2 Press

to set Timer mode. OUT2 indicator on screen will appear.

4.2.1 You will see

4.2.2 Use

to enter the value. Press

4.2.3 You will see

value. Press

DIGISYSTEM LABORATORY INSTRUMENTS INC.

INSTRUCTION MANUAL FOR DRY BATH DSD-100D & DSD-200D

key to select time unit

to next setting.

. Use

to next setting.

. Press

to adjust SV value and then press

or Timer mode

(hour) or

key to adjust the time value. Press

www.digisystemlab.com

Block

Block lifter

(minute). Press

to enter the

REV.2-2020