Sharp CD G14000 Instrukcja obsługi - Strona 35
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System stereo Sharp CD G14000. Sharp CD G14000 48 stron. Mini component system
Drukuj stronę
To perform programmed recording:
1 Program discs and tracks. (See page 25.)
2 Press the
button.
3 Press the
/
button.
To stop recording:
Press the
button.
The disc and tape will stop.
Recording from the radio
1
Tune in to the desired station. (See page 30)
2
Load a cassette into the TAPE 2 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the
button.
Recording will be paused.
4
Press the
/
button to start recording.
To interrupt recording:
Press the
button.
To resume recording, press the
To stop recording:
Press the
button.
Note:
If you hear a whistling noise while recording an AM station, move the
AM loop antenna.
/
button.
Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette
into
the
TAPE
1
cassette
compartment. Insert a blank
tape into the TAPE 2 cassette
compartment.
It is recommended that the recording tape is the same length as
the master tape.
3
Press the TAPE (1
2) button until "TAPE 1" appears on
the display.
4
Press the
button.
Recording will be paused.
5
Press the
/
button to start dubbing.
To stop dubbing:
Press the
button.
TAPE 1 and TAPE 2 will simultaneously stop.
Erasing recorded tapes
1 Load the tape to be erased into the TAPE 2 cassette
compartment with the side to be erased facing toward you.
2 Press the TAPE (1
2) button until "TAPE 2" appears on the
display.
3 Press the
button.
4 Press the
/
button to start erasing.
Note:
Make sure that the TAPE 1 is not in use.
CD-G14000
CD
5
4
3
PRESET
2
PRESET
1
TUNING
VOL.
TUNING
— VOL.
AUDIO IN
PHONES
TAPE 1
TAPE 2
35