Sharp CD-C491H Instrukcja obsługi - Strona 25

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System stereo Sharp CD-C491H. Sharp CD-C491H 48 stron. Mini component system

Drukuj stronę

1. Specifications

(Continued)

PTY.TI

EON

Jog dial

Notes:

During the same programme as the specified PTY (or TA)

is being broadcast on the station you are receiving, the

unit will not switch to other network station.

If there are more than two other network stations you want

to listen to, compare the strength of each station's signal

and tune in the station with the strongest signal. (EON-AF)

However, if the frequency of other network station has

been stored in the preset channel memory, the unit will

switch to that preset channel.

EON-TI

Tune in the desired RDS station, then the PS name will

be displayed.

Press the EON button when "EON" appears.

"PTY.TI" and "SELECT" will appear alternately for about

4 seconds.

Whilst they are being displayed, select the TI (Traffic In-

formation) turning the jog dial.

The selected "TI" will flash.

Within 4 seconds, press the PTY.TI SEARCH button.

"TI" and "WAITING" will appear for 2 seconds each.

"TI" will appear, and the unit will enter the EON-TI stand-by

mode.

When a TA specifed starts on a other network station,

the unit will automatically switch to that station, and "TI"

will flash.

When the traffic announcement is over, the unit will au-

tomatically return to the original station you were tuned

to.

Note:

If the EON button is pressed when "EON" is not displayed,

"NO EON" will appear for 4 seconds to indicate that the

unit cannot enter the EON stand-by mode.

Checking the stand-by mode setting:

When in the EON stand-by mode, press the EON button.

("TI"

To cancel the EON stand-by mode:

When in the EON stand-by mode, press the EON button.

Within 4 seconds, press it again. The EON stand-by mode

will be cancelled.

"TI" will go out.

Note:

If neither "TP" nor "TA" appear, then even if "EON" ap-

pears the unit cannot enter the EON-TI stand-by mode.

In this condition, even if the EON button is pressed, "NO

TI" will flash for 4 seconds.

If you want to cancel the reception of an ON (other net-

work) station which was tuned in by the EON system and

return to the original station you were receiving, press the

EON button.

After the unit returns to the original station, the stand-by

mode will still be active. (The "TI" or "PTY" will remain lit.)

The unit will not switch from the ON station to another

network station. The unit returns to the original station.

When the unit switches automatically to "other network"

station, if there is any problem with this station or the

station cannot be received properly, "NO READY" will ap-

pear and the unit will return to the original station.

CD-C491H(SUK) TINSE0229AWZZ

"WAITING")