Sharp CD-G100000 Instrukcja obsługi - Strona 41

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System stereo Sharp CD-G100000. Sharp CD-G100000 47 stron. Mini component system

Drukuj stronę

Headphones

Before plugging in or unplugging the headphones, reduce the

volume.

Be sure your headphones have a 1/8" (3.5 mm) diameter plug

and impedance between 16 and 50 ohms. The recommended

impedance is 32 ohms.

Plugging in the headphones disconnects the speakers automati-

cally. Adjust the volume using the VOL. control.

Troubleshooting chart

Many potential problems can be resolved by the owner without call-

ing a service technician.

If something is wrong with this product, check the following before

calling your authorized SHARP dealer or service center.

General

Symptom

The clock is not set to the

Did a power failure occur? Reset

correct time.

the clock. (Refer to page 19.)

When a button is pressed,

Set the unit to the power stand-

the unit does not respond.

by mode and then turn it back on.

If the unit still malfunctions, reset

it. (Refer to page 43.)

No sound is heard.

Is the volume level set to "0"?

Are the headphones connected?

Are the speaker wires discon-

nected?

CD player

Symptom

Playback does not start.

Is the disc loaded upside down?

Playback stops in the mid-

Does the disc satisfy the stan-

dle or is not performed

dards?

properly.

Is the disc distorted or

scratched?

Playback sounds are

Is the unit located near excessive

skipped, or stopped in the

vibrations?

middle of a track.

Is the disc very dirty?

Has condensation formed inside

the unit?

CD-G10000

CP-G10000S

Possible cause